1 5

Dillon XL650/XL750 Case Ejector, Powder Knob, Pickup tube and Primer rod holder.

Dillon XL650/XL750 Case Ejector, Powder Knob, Pickup tube and Primer rod holder.

$16.00 USD
$16.00 USD
Sale Sold out
You will receive

2pcs  Bearing / Bushing type Case Ejectors  
1pcs  Powder Measurer Dial Knob  
1pcs  Primer Pickup Tube / Magazine tub and Primer follower rod Holder  ( three holders in one part ) 


3D Printed Case mounted Primer Pickup Tube Holder / Primer follower rod holder .  

It has 11 slots for Primer pickup tubes and or Small / Large Primer Magazines tubes , Plus has a mount on either end to hold your Primer Follower Rod .  This part can be mounted on either side of your case feeder and still have easy access to all your tubes and your follower rod.

            

What sets this item apart from the others .


1 . Holds 11 pickup tubes and or L/S magazine tubes .

2.  Has 2 mounts on the either end for your Primer Follower Rod .

3 . Uses two Stainless Steel set screws for secure mounting to the case feeder.

4.  Tubes are securely held in place with the use of deep  drop down slots .

5.  Numbers on eleven slots

6.  Can be mounted anywhere on the case feeder and have easy access to the Primer Follower Rod .

7. Saves work bench space and organizes all your tubes in one location . 

8. Save money by getting two holders one part. 




Powder Measure Knob.  Fits any Dillon 7/16 ( 11.1mm ) powder measure screw head . 

1. Has easy to read markings on BOTH sides of the dial.  

2. Has a Setscrew and nut that locks the Knob onto the Powder measures screw head .  This makes for a Firm / tight connection that doesn't get sloppy and makes switching to other Hoppers fast and easy . ( UNLIKE Press fit versions that get wobbly and loose every time you handle or remove them  .    )

3. Has 45 Indication marks on back face . Very useful if you decide to setup a pointer .

4. Dial is 1.600 Inches in Diameter by 0.450 Inches Thick for easy handling and tight profile to the reloader.   

5. All hardware is Stainless Steel .

 

Upgraded Case Ejector  


This case ejector has been tested on .380 acp up to 45 acp . Also .223/5.56  

This is a 3D printed part and is My Redesign to fix issues I've ran into with some of the current available Ejectors designs.  

1. Moved the location of the setscrew and square nut, so you can access it when the shellplate has cases / rounds in it. .  

2. Added fillets and thickened up the area where the square nut is located to help prevent stretching.

3. Increased clearance between the ejector and the case insert slide to prevent binding and to ensure case insert slide has full travel. 

4. Increased  clearance between case insert slide and the finished round chute . Allows so more caliber uses and ability to adjust rotation for the perfect case ejection

5 The hardware is stainless steel . 

View full details